Push Fit Internal Bushes – Internal Bushes for Pole Top Kit (2 Pieces)

Drennan Push Fit Internal Bushes – extra-long PTFE bushes for pole elastic

The Drennan Push Fit Internal Bushes are extra-long, internally fitted bushes for the tip of a pole. They are made from 100% pure PTFE, allowing the pole elastic to run through the tip along a smooth surface. This helps reduce friction and wear while supporting smooth stretching and retraction of the elastic.

The extra length gives the bush a large contact area inside the pole tip. The knurled exterior is designed for a stable push-fit and reduces the amount of glue needed when correctly fitted. Choose the size based on the opening in the tip and the required bore for your elastic; refer to the variant selector for this.

Key features

• Internally fitted bush for pole tips
• Extra-long design for a large contact area
• Made from 100% pure PTFE
• Helps reduce friction and wear on pole elastic
• Supports smooth stretching and retraction of the elastic
• Knurled exterior for a stable push-fit
• Supplied in packs of two

Frequently asked questions

How do I determine which internal bush fits my top kit?
Measure the internal diameter of the finished tip opening and check that the bore is sufficiently wide for the chosen elastic. The bush should fit securely in the tip without putting the carbon under tension.

Why is this internal bush extra long?
The extra length increases the contact area between the bush and the pole tip. This helps keep the bush stably aligned and distributes the fit over a larger section of the tip.

How do I safely prepare the pole tip for fitting?
Only shorten the tip when necessary, make the cut square and smooth, and remove sharp carbon fibres. First test the fit dry and use only a small amount of suitable glue if extra securing is needed. If in doubt, have the fitting carried out by an experienced rod builder.

Official product video