Flatside Soft Pullerbeads – Soft Puller Beads with Flat Side

Cresta Flatside Soft Pullerbeads – stable puller beads for a puller system

The Cresta Flatside Soft Pullerbeads are made from strong yet elastic-friendly rubber. The tapered hole grips the hollow elastic, while still allowing you to move the bead to adjust the tension of your top kit setup as desired.

The flat rear side sits neatly against the puller lock and therefore protrudes as little as possible. The soft material also prevents the bead from rattling hard against the rod section. The pack contains three sizes, allowing you to match the bead to different diameters of hollow elastic.

Key features

• Strong, elastic-friendly rubber
• Tapered hole for reliable grip
• Adjustable to set the elastic tension
• Flat rear side fits neatly against the puller lock
• Soft material reduces rattling against the rod
• Three sizes per pack

Sizes and application

• L: 1.20 mm opening, suitable for hollow elastic from 1.5 to 2.2 mm
• XL: 1.5 mm opening, suitable for hollow elastic from 1.8 to 2.6 mm
• XXL: 2.0 mm opening, suitable for hollow elastic from 2.2 to 4.0 mm

Assembly tip

Slide the suitable puller bead onto the elastic and tie a sufficiently large, strong knot behind the bead. Before use, check that the knot cannot pull through the opening and that the bead rests flat against the puller lock.

Frequently asked questions

Why does the bead have a flat rear side?

This allows the puller bead to sit neatly against the puller lock and protrude less along the rod section.

Can I still move the bead after fitting it?

Yes. The tapered hole grips the bead on the elastic, but allows you to deliberately move it when you want to adjust the tension.

Which size should I use for my elastic?

Choose the size whose stated range matches the diameter of your hollow elastic. The pack contains L, XL and XXL.